UTP Cable Crimping Method

Step By Step UPT Cable Crimping Method:

1. Before making the cable we need to peel out of utp cable during stripping about 1 inch from the end of his order at the time of mounting RJ45 crimping can result in a good and strong.





2. Sure at the time of peeling the outer wires of the cable wires are not in any order within a cable can be connected to either cut or scratched if it is in the early going well but after some time will be damaged and no longer connected



3. After peeling the outer cable is the next step and separate the wires in alignment on each cable so the crimping cable Pls That Produce berkualitas.pisahkan the orange wire to the left and right color of brown and then We separate the pair of green and white color green green. white to the left


and green to the right then stay to parse the blue pair in the middle so That the decomposition process Easier and more efficient cables.

4. We have to straighten each wire conductor into a sequence that complies with the standard cable pengkabelan.bagaimana sequence? standard cable in the call sequence with the sequence 568-B for a more clear cable can be viewed below is clear on the arrangement of the cable conductor on each type of wiring topology, there is for straight cable and crossover cable, if it is clear we go to step 5.




5. The next step we cut all the cable conductors in Squeeze your way all the cables that had been in alignment try to cut it flat with a 90 degree angle about 1 / 2 inch from the outside wires, do not cut the cable is too short so that it will be gripping the conductor contacts on the RJ45 .

6. The next steps include conductor cable to make sure the RJ45 cable conductor in order to firmly hold the cables do not experience a shift in the composition of the cable (not flat) and input cable with the orange color of the initial order from the left and input to the RJ45.

7. Get in on lawyer-stage crimpingan.pada this stage be sure re-enter the results of the cable into the RJ45 cable and try and push up into the RJ45 contacts on each conductor cable and press the tool crimpping to read "click" on the RJ45.

8. If it is on the cable end of the first to do way over to repeat his or her needs kedua.jika cable ends are straight arrangement of the first cable equal right with the second cable, if you need a crossover cable descriptions distinguish it as the following example:


like the picture above if you want to make a straight wire of each cable end with an array of straight and if you want to make a crossover cable using the composition of the first straight edge and the second end using a crossover.